DON’T NEGLECT THESE THREE COMPONENTS DURING SPRAYER WINTERIZATION

Though the major components of a sprayer – product system, rinse loop, agitation and inductor loops – deserve much of the attention during the winterization process, it’s important not to neglect other parts and components that are important to the machine’s operation during the growing season. And, the right winterization now can prevent costly and time-consuming breakdowns and delays when it’s time to spray next year.

 

Once you’ve winterized your sprayer’s application system, there are other components to attend to before you put the machine away for its winter nap. Any gauges and controllers should be part of the winterization process, said Apache Sprayers Senior Application Specialist John Casebolt.

 

Pressure system gauges

If your Apache Sprayer is equipped with pressure system gauges, it’s important to ensure both the boom pressure gauge and the agitation pressure gauge are first disconnected, then cleaned and prepared similar to the process for the product system. Look for the gauges on the right front corner of the Apache cab, and make sure the plumbing running to and from the gauges is properly rinsed, dried and winterized with antifreeze, according to Casebolt.

 

“Unplug each one of those gauges, leave the tubing hanging freely and run some antifreeze through that tubing to flush out any of the water and chemical that might be in there,” he said. “Then, go ahead and reconnect the tubing, but we’re going to remove the gauges, so we don’t have trouble if they freeze up. We’re going to take those gauges off the machine, store them in a warm, dry place and we’re going to plug the ports where they plug into, so we don’t get dirt or debris in them in the wintertime if the machine’s going to be stored outside.”

 

Strainers

Though they’re small components, strainers can add up to a lot of headaches during the growing season if not attended to in the offseason, including when winterizing your sprayer. It’s best to first drain and clean strainers, then store them off the machine in a warm, dry location to avoid damage from freezing temperatures

 

“Drain down the Y-strainer and boom valve strainers on the back of the machine,” Casebolt said. “That way, we can remove those strainers and put them in a bucket of clean water or tank-cleaning solvent to try to clean those strainers up during the wintertime.”

 

Product system controllers

In-cab electronic controllers should also be removed when winterizing your sprayer, especially if stored in a cold location. Current systems available in Apache Sprayers, like the Raven Viper® 4 product pump control or 600S GPS receiver, can withstand cold temperatures, but it’s best to store such electronic equipment in a warm, dry place, as temperature fluctuations can sometimes damage internal components.

“Come spring time, we’ll plug it back in and the settings should be retained, and we should be ready to go,” Casebolt said.

 

For more information on winterizing your Apache Sprayer, consult your owner’s manual or contact your local dealer.

 

This entry was posted in Ask the Application Specialists, Maintain Your Sprayer. Bookmark the permalink. Follow any comments here with the RSS feed for this post. Trackbacks are closed, but you can post a comment.

Post a Comment

Your email is never published or shared. Required fields are marked *

*
*

 

Copyright © 2019 Equipment Technologies, Inc. All Rights Reserved.
Privacy Policy    |    Terms & Conditions    |    Site Map

Limited Time Offer: No interest, no payments until 2020. Learn More